Select from a range of nuts for HPLC: 1/16th" or 1/8th" for use with PEEK, polymeric or stainless steel nuts.
Quality fittings for HPLC connections are necessary for consistent performance of any HPLC or HPLC method. Use only high quality, precision pieces that are backed by technical support.
Use the quick links below to view images and more information for some of the different types of our most popular fittings.
The CombiHead Hex™ is one of our most popular nuts for HPLC. You can finger tighten or use a wrench for that extra 1/4 turn that is needed. This assures a better seal quickly. This eliminates any "hand fatigue" from finger tight fittings.
CombiHead flats™ have a "flat area" provided to wrench the last 1/4 turn. This assures that your high-pressure fitting is sealed and less likely to leak and is also convenient when removing the fitting. Use a wrench to "break" the seal and remove the fitting's remaining turns by hand; this eliminates hand and finger fatigue.
The Endure™ line of nuts for HPLC are made for extra durability. Constructed of carbon-PEEK materials, these nuts will endure higher temperatures, more solvent exposure and most over-tightening compared to standard PEEK fittings. Choose from built in ferrules (1-piece) with a wide variety of shapes for different applications.
Variety of PEEK nuts that can be finger tightened are available as one or two pieces. The one-piece is very convenient and very common in HPLC labs. Two-piece nuts with double cone ferrules will last longer and give better seals than one-piece PEEK nuts.
Stainless steel nuts for the best connection are available as two-piece units with a nut and ferrule. Choose from 3 lengths of nuts to meet your specific need. All of our stainless-steel fittings are manufactured from SS 316L (DIN 1.4435) with standard HPLC threads.
Low pressure nuts for upstream (before the pump) or downstream (post detector) HPLC are offered in two types: Flanged or flange free. With flanged nuts you will need to create a flange on your polymer tubing. Click HERE for the flanging tool ordering information.
It is recommended to only use PEEK or ETFE fittings and ferrules for mobile phase connections that are immersed into the mobile phase solvents. Click HERE for more information on this topic.
The selection "FILTER" buttons below refine the products displayed in the ordering chart & image grid. They are described below and listed alphabetically by FILTER.
